Monday, April 6, 2015

Nevin's first ride

Today I taught Nevin to ride on the Kl250.   Since my plan was to get the bike running and use it to teach both of my sons to ride on it, that felt good.  He learned very quickly, popped a wheelie the first time he pulled the clutch out!  I am a bad teacher, but nobody got hurt.


Add caption

Installed new chain

The chain was at its limits, and the sprockets were both like-new.  I purchased the cheapest o-ring chain that I could find on ebay.   It arrived today so it got installed.

Monday, March 30, 2015

Kyle's first ride

Today, Kyle and I went to Farm and Fleet to get him a helmet.  We brought the bike with using the Harbor Freight motorcycle carrier, to test that out.  There are trails behind the store, where I have taken my KLR a few times.  We had a great time, and Kyle learned really fast.  I'm already looking forward to the next time... hopefully with my KLR and more time to kill!

Kyle got stuck in the same spot twice, but did not drop it either time
This was the second time getting stuck, a classic 'no need for a kick stand' moment!
The Harbor Freight motorcycle carrier did fine, but our Jeep Patriot's suspension sagged a little too much

Tuesday, March 24, 2015

New tires!

I removed the wheels on Tuesday and this is how the bike sat until Saturday when I re-installed them with their new Kenda K270's.  New treads just seem to make the bike look much better.

Waiting patiently for new treads


Wednesday, February 25, 2015

Installed intake and exhaust

I had to remove the rear tire in order to install the exhaust, but no big deal w/o the chain.  The intake side was nice and easy without an airbox.  I will have to rejet after we get it running of course.
46mm pod filter from Amazon.com
The carb looks nicer without the accelerator pump
Yes, that is electrical tape on the carb holder... for now
Gotta paint the header at some point
The muffler mod was performed by the PO

Tuesday, February 17, 2015

Extracted a broken bolt and installed handlebars

When I began to install the handlebars (just to make it easier to roll the bike around), I found a broken bolt in the top clamp.  Luckily, I had a set of handlebar bolts from a previous parts bike.  Fortunately, the remnants of the bolt came out easily.



These bars are very temporary

Inspected the parts bike carburetor

Since it was sitting in a box, I figured it would be wise to do a quick inspection of the carb before installing it.  It looked pretty clean and correct, except for the brass pipe that extends from the bowl into the choke - side of the throat.  I believe there is a tiny hole at the tip, which was clogged.  Also, the pilot air screw was MIA along with a couple of o rings and a spring for the accelerator pump.  I found the pilot screw on ebay using the Kawasaki p/n, and the accelerator pump circuit will most likely get bypassed when we re-jet.
I just realized that this is the jet for the accelerator pump, so this clog is irrelevant if we bypass it!
Checking the float height; about 21mm with a slight push down